HotBelt Refrigerant Jug Warmer
The HotBelt™ is a product designed specifically for HVACR professionals. The ideal solution for pre-heating and keeping refrigerant jugs warm when servicing HVACR systems in cold environments. The HotBelt™ provides increased efficiency by speeding up service times and reducing wasted refrigerant materials. The adjustable strap allows for a hook and loop to fit several size jugs.
- 120 volt
- NEMA 5-15P
Since 1949
Additional Features:
- Adjustable fit design with hook & loop strap fits common size cylinders: 30 lb, 50 lb, and 125 lb (13 kg, 23 kg, 57 kg)
- Designed to heat the tank surface to 120°F (49°C)
- Moisture and chemical resistant - IP56 rated
- 6 ft (1.8 m) long power cord with choice of plug
- Simple plug and play design
- Rugged - provides long service life and can be used in a wide variety of environments
Safe to use with common refrigerants:
- R-140A
- R-407C
- R-139A
- R-22
- R-404 and more
Heater Width: 6 in (152 mm)
Length: 26 in (660 mm)
Thermostat: Thermostat is preset to 158°F (70°C) and the heater is designed to heat the surface of the tank to 120°F
(49°C)
Exposure Temperature: -60°F to 450°F (-51°C to 232°C)
Voltage: 120, 230, or 240 VAC
Power Density: 1.4 W/in2 (0.2 W/cm2)
Dielectric Strength: Over 2000 volts
Silicone Rubber Density: 46.0 oz/yd² (1560 g/m²)
Closure Method: Adjustable strap
Cylinder Diameter Range: Minimum 9 in (229 mm)
Power Cord: 6 ft (1.8 m) long with choice of power plug
IP Rating: IP56
*Variations in ambient temperature and material contents within the cylinder may affect actual surface temperature of the cylinder
| Part No. | Voltage VAC | Plug Type | Total Watts |
| HB1001 | 120 | NEMA 5-15P | 200 |
| HB2001 | 240 | NEMA 6-15P | 200 |
| HB2002 | 230 | CEE 7/7 | 200 |