ACR miniPRO Hot Bonder

• Easiest-to-use, fully-loaded hot bonder under 18 lbs (8 kgs)
• Full-color touchscreen interface
• Built-in vacuum venturi
• 20 or 30 amp output
• 10 thermocouple sensors
• Audible and visual alarms for high and low temperature / vacuum limits
• Fast and simple data transfer with USB drive

• Small and lightweight — cure composite materials anywhere
• Easy-to-carry and setup — even up towers, ladders, staircases, and on wings
• Intuitive graphical touchscreen interface is easy-to-program and use
• Secure — multiple levels of password protection
• Transfer your programs quickly from one bonder to another
• Simple post-cure data transfer and analysis — files can be transferred easily with USB drive and opened with spreadsheet and word processor programs including Microsoft® Excel® and Word®
• Rugged — hot bonder is enclosed in extra durable, high-impact hard case
• Multi-language support including English, German, Russian, and Chinese (Mandarin). Additional languages available upon request
• Update your hot bonder easily with the latest FREE software at www.BriskHeat.com

General

• Single zone
• 8.4" (213mm) touch-screen with easy-to-use interface
• USB port for data transfer (USB flash disk included)
• Input ground fault interrupter breaker protected
• Audible and visual alarms for high and low temperature / vacuum limits
• Data logs digitally
• Compact size of 16.44”L x 13.13”W x 6.81”D (41.75cm x 33.34cm x 17.30cm)
• Weighs less than 18 lbs (8 kg)

Temperature Control

• Cure up to 1400^oF (760^oC)
• 10 J-type thermocouple sensor inputs
• Accuracy: ±3°F (1.67°C)
• Monitors all thermocouples for alarms
• Data logs digitally: records real-time status of cure including program parameters

Software

Power

• Input Voltage: 100-130VAC, 200-240VAC
• Input ground fault interrupter breaker protected
• MAINS supply voltage fluctuations up to ±10% of the nominal voltage
• Transient over voltages typically found on a Category II power source: i.e. a lighting circuit
• Frequency: 50-60Hz
• 20 amp capacity (30 amp optional)
• Output cord receptacle: NEMA L15-30R 

Vacuum

• Vacuum venturi (requires compressed air)
• Pressure: Up to 28in Hg (13.8PSI)
• Ability to manually adjust pressure

Environment

• Intended for use in dry environments. Do not expose to spray.
• Altitude up to 6562ft (2000m)
• Storage temperature range: -4 to 140^oF (-20 to 60^oC)
• Operating temperature range: 41 to 104^oF (5 to 40^oC)
• Maximum relative humidity: 80% for temperatures up to 88^oF (31^oC) decreasing linearly to 50% relative to humidity at 104^oF (40^oC)
• Pollution degree 2 (normally only non-conductive pollution occurs, however a temporary conductivity caused by condensation must be expected)

Part Number: ACR-3-MINI

Includes:

• One ACR MiniPRO hot bonder unit
• One 10ft (3m) vacuum hose
• One vacuum bag feed-through
• One 10ft (3m) input power cord
• One 5ft (1.5m) heater output power cord
• One USB flash disk
• 10 J-type thermocouples
• 10 Standard connector adapters for thermocouple receptacles

• Aircraft repair
• Challenging field repair
• Wind turbine blade repair - even up-tower
• A wide variety of industries and uses: sporting goods, automotive, marine, recreational vehicles, racing and more